Drain Cleaning & Repair in Atlanta, Ga.
Suffering from slow or clogged drains? No problem, call the Atlanta plumbers at Ridgeway Mechanical for fast and honest drain cleaning and repair service in Atlanta. You see, once we use the incoming water from our faucets, toilets, showers or tubs, it has to have somewhere to go, right? The drainage system inside your Atlanta home is an indispensable part of your total plumbing system, carrying waste and used (gray) water to the sewer or septic system outside. Indoor drainage systems have been a part of homes for centuries, and as such the materials and construction of drain system’s components have changed a bit. Some of these changes have been due to improvements in piping materials, while others have come about due to code changes and requirements. Atlanta plumbing code requirements change frequently and dictate that indoor drainage systems be constructed in a certain way, regardless of how many bathrooms are in the home. Drain pipe size and configurations is calculated based on the size and layout of the home. They must still conform to certain rules.
Drain pipe materials in older homes consisted mostly of thin-walled stainless steel, copper, lead, and cast iron. The steel, copper, and lead were usually found under sinks, while cast iron was found in walls and basements or crawlspaces, forming the main sewer system for the home. A very common Atlanta plumbing configuration for an under-sink drain setup was as follows: thin-wall stainless, soldered into a copper stub, then soldered into a lead stub, with the lead then connected to the cast iron. That’s FOUR different materials all connected within a few feet of each other, all susceptible to corrosion or rust. As such, leaks are very common in these locations. With so many failure points, problems were imminent. When one of these leaks occur, we make the repairs with PVC (poly-vinyl chloride) piping, which is an extremely durable, clean, and inexpensive type of plastic pipe. We remove as much of the older metal piping as possible, often leaving you with brand new drainage all the way back into the wall and reaching the cast iron (which is less prone to leaks).